ISO 4000-2:2007 pdf download – Passenger car tyres and rims
1 Scope
This part of ISO 4000 specifies the designation, contour and dimensions of 5° tapered (drop-centre) rims primarily intended for passenger cars.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3911, Wheels and rims for pneumatic tyres — Vocabulary, designation and marking
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 3911 apply.
4 Designation and marking
The rim shall be designated by its nominal rim-diameter code, nominal rim-width code and rim, flange type
5 5° tapered (drop-centre) rims
5.1 Rim flanges
Recommended rim flange contours are given in Table 1 for the nominal rim diameter codes.
5.2 Rim contours
Dimensions and tolerances of the rims shall be as given in Figure 1 and Table 2. Optional bead seat contours and their dimensions are given in Figure 2 and Table 3.
NOTE For use with tubeless tyres, humps are necessary on the mounting side and preferred on the non-mounting side.
5.3 Rim diameter and hump circumference
The specified rim diameter, D, for nominal rim-diameter codes and hump circumferences is given in Table 4.