BS ISO/IEC 29341-12-2:2015 pdf download-Information technology — UPnP Device Architecture Part 1 2-2: Remote User Interface Device Control Protocol — Remote User Interface Server Device

01-19-2022 comment

BS ISO/IEC 29341-12-2:2015 pdf download-Information technology — UPnP Device Architecture Part 1 2-2: Remote User Interface Device Control Protocol — Remote User Interface Server Device.
2. Device Definitions 2.1. Device Type The following device type identifies a device that is compliant with this template: urn:schemas-upnp-org:device:RemoteUIServerDevice:1 2.2. Device Model It is recommended that RemoteUIServerDevice be implemented with support for securing UPnP™ actions. It is also recommended that securing of UPnP™ action is done using the DeviceSecurity service as defined by the UPnP™ security working committee. If implemented, the DeviceSecurity service must be contained either inside RemoteUIServerDevice implementation or in a device that encompasses the RemoteUIServerDevice. These two models are described below. 2.2.1. Description of Device Requirements The following table briefly describes the service used in RemoteUIServerDevice.
2.2.1.1. DeviceSecurity within RemoteUIServerDevice This model is typically applicable to physical devices that need DeviceSecurity functionality (including device ownership and access control) to be used only by the RemoteUIServerDevice. In this case, products that expose devices of the type urn:schemas-upnp-org:device:RemoteUIServerDevice:1 must implement minimum version numbers of the required service specified in the table below.
2.2.1.2. DeviceSecurity outside RemoteUIServerDevice This model is typically applicable to physical devices that implement Remote UI server functionality, but the RemoteUIServerDevice may use DeviceSecurity that is already part of another device. An example of this would be where urn:schemas-upnp-org:device: RemoteUIServerDevice:1 is implemented inside a device of the type urn:schemas-upnp-org:device: BasicDevice:1. The BasicDevice in this case contains the DeviceSecurity service that may be used by another UPnP™ device e.g., MediaRenderer. The implementation of RemoteUIServerDevice must contain the minimum version number of the service specified in the table below.
Relationships between Services Figure 2 shows the logical structure of the device and services defined by the working group for UPnP™ technology enabled Remote UI servers that may use the DeviceSecurity service for other UPnP™ devices contained in the same physical device. RemoteUIServer service may be dependent on the DeviceSecurity service for providing access control to the actions defined in the services.

Download Link Download
PS: If you don't mind, please turn off your ad blocker.
AS/NZS IEC 60601.1.3:2015 pdf download-Medical electrical equipment Part 1.3: General requirements for basic safety and essential performance— Collateral Standard: Radiation protection in diagnostic X-ray equipment IEC standards free download

AS/NZS IEC 60601.1.3:2015 pdf download-Medical electrical equipment Part 1.3: General requirements for basic safety and essential performance— Collateral Standard: Radiation protection in diagnostic X-ray equipment

AS/NZS IEC 60601.1.3:2015 pdf download-Medical electrical equipment Part 1.3: General requirements for basic safety and essential performance— Collateral Standard: Radiation protection in diagnostic X-ray equipment. 5.2.4 Instructions for use Additionally to the requirements of the general standard...
   Read More
AS/NZS IEC 60947.4.2:2015 pdf download-Low-voltage switchgear and controlgear Part 4.2: Contactors and motor- starters—AC semiconductor motor controllers and starters IEC standards free download

AS/NZS IEC 60947.4.2:2015 pdf download-Low-voltage switchgear and controlgear Part 4.2: Contactors and motor- starters—AC semiconductor motor controllers and starters

AS/NZS IEC 60947.4.2:2015 pdf download-Low-voltage switchgear and controlgear Part 4.2: Contactors and motor- starters—AC semiconductor motor controllers and starters. 3.3 Terms and definitions concerning a.c. semiconductor motor controllers and starters 3.3.1 semiconductor switching device switching device designed...
   Read More
AS/NZS IEC 60947.5.5:2015 pdf download-Low-voltage switchgear and controlgear Part 5.5: Control circuit devices and switching elements—Electrical emergency stop device with mechanical latching function IEC standards free download

AS/NZS IEC 60947.5.5:2015 pdf download-Low-voltage switchgear and controlgear Part 5.5: Control circuit devices and switching elements—Electrical emergency stop device with mechanical latching function

AS/NZS IEC 60947.5.5:2015 pdf download-Low-voltage switchgear and controlgear Part 5.5: Control circuit devices and switching elements—Electrical emergency stop device with mechanical latching function. 4.3 Additional requirements for trip wire switches Information provided by the manufacturer shall include:...
   Read More
AS/NZS IEC 60947.5.6:2015 pdf download-Low-voltage switchgear and controlgear Part 5.6: Control circuit devices and switching elements—DC interface for proximity sensors and switching amplifiers (NAMUR) IEC standards free download

AS/NZS IEC 60947.5.6:2015 pdf download-Low-voltage switchgear and controlgear Part 5.6: Control circuit devices and switching elements—DC interface for proximity sensors and switching amplifiers (NAMUR)

AS/NZS IEC 60947.5.6:2015 pdf download-Low-voltage switchgear and controlgear Part 5.6: Control circuit devices and switching elements—DC interface for proximity sensors and switching amplifiers (NAMUR). 6 Product information Characteristic product data shall be stated by the manufacturer together...
   Read More

LEAVE A REPLY

Anonymous netizen Fill in information