IEC 60747-14-2:2000 pdf download-Semiconductor devices – Part 14-2: Semiconductor sensors – Hall elements.
2.2 Ratings (limiting values) 2.2.1 Temperatures 2.2.1.1 Minimum and maximum storage temperatures (T stg ) 2.2.1.2 Minimum and maximum operating temperatures (T opr ) 2.2.2 Bias 2.2.2.1 Maximum control current (I cmax ) 2.2.2.2 Maximum control voltage (V cmax ) 2.2.3 Derating curve 2.2.3.1 Control current derating curve Maximum control current at each temperature shall be stated or be depicted in the form of a figure. 2.2.3.2 Control voltage derating curve Maximum control voltage at each temperature shall be stated or be depicted in the form of a figure. 2.3 Characteristics Characteristics are to be given at 25 °C, except where otherwise stated; other temperatures should be taken from the list in IEC 60747-1, chapter VI, clause 5. 2.3.1 Unloaded electrical characteristics 2.3.1.1 Output Hall voltage (V H ) Maximum and minimum values, at a specified magnetic flux density and control voltage or current, at an operating temperature of 25 °C. 2.3.1.2 Input resistance (R in ) Maximum and minimum values, at a specified voltage or current without any magnetic flux density, at an operating temperature of 25 °C. 2.3.1.3 Output resistance (R out ) Maximum and minimum values, at a specified voltage or current without any magnetic flux density, at an operating temperature of 25 °C. 2.3.1.4 Offset voltage (V o ) Maximum and minimum values, at a specified control voltage or current without any magnetic flux density, at an operating temperature of 25 °C. 2.3.1.5 Temperature coefficient of output Hall voltage (α V H ) Average value at a specified temperature range (understood as the range given in 3.6.4), at a specified control current under specified magnetic flux density.
2.3.1.6 Temperature coefficient of input resistance (α Rin ) Average value at a specified temperature range (understood as the range given in 3.7.3), at a specified control current without any magnetic flux density. 2.3.1.7 Dielectric strength Maximum and minimum values at a specified voltage with respect to any external surface of the device. 2.3.2 Dimensional drawing 2.3.2.1 Dimensions The drawing shall provide dimensions with specified tolerance. 2.3.2.2 Position of terminals The position of the four terminals shall be shown in the figure.
IEC 60747-14-2:2000 pdf download-Semiconductor devices – Part 14-2: Semiconductor sensors – Hall elements
PS:
If you don't mind, please turn off your ad blocker.